How do I connect to the UniSQ Wi-Fi (eduroam) on my iPhone or iPad (iOS) device?
Updated
The Wi-Fi connection used at UniSQ is called eduroam.  Once set up, your mobile device will automatically connect when you come onto any UniSQ Campus.
 
Note: The below process is for when you're at a UniSQ campus.  Steps match the process experienced on iOS version 16.1.2 and may vary with older devices.
 
  1. Go into Settings > Wi-Fi
  2. Click UniSQ-Visitor from the Wi-Fi listing
  3. Open the Safari Browser and navigate to http://wireless.usq.edu.au which will redirect you to the UniSQ Wi-Fi portal page 
  4. Tap Follow this link to connect to 'eduroam' located at top of the page
  5. Enter your UniSQ Username followed by @usq.edu.au (e.g. U1234567@usq.edu.au)
  6. Next to 'Select your device', check that iPhone/iPad option is selected
  7. Tap Join Now
  8. You will be asked if you want to download a configuration profile, tap Allow
  9. You will receive a message advising Profile Downloaded, then tap Close
     
  10. Go into Settings
  11. Tap on 'Profile Downloaded' located near the top of your screen
  12. Tap Install
  13. Enter your Apple iPhone/iPad passcode
  14. Read the Warning message and tap Install, then tap the pop-up Install
  15. Enter your UniSQ Password
  16. Tap Next
  17. Tap Done
  18.  In your iPhone settings, navigate back to Wi-Fi
  19.  After a few moments your iPhone will now connect to eduroam (if it doesn't please tap on 'eduroam' to connect)

 

Off-campus Setup
 
If you are not near the eduroam network or UniSQ campus, you can setup the connection while connected to another network.
 
1. Access link here
2. Follow steps above from step 5
 
If you require additional assistance, please go to iconnect and log a request
Print

Is this answer helpful?